|
you are here: home page :: circuit diagrams :: Radio devices
Radio devices - list of circuit diagrams
A circuit that has been found to work at full satisfaction in the frequency range from 10 kHz to 500 kHz
author: Ramon Vargas - Lima, Peru visits: 634 
This project has few components, can be made on veroboard and powered from a 9 volt battery for portability
author: Andy Collinson visits: 540 
This is a VHF amplifier for the Band 2 Radio Spectrum tuning approximately 88 - 108 Mhz
author: Andy Collinson visits: 529 
A complete AM radio set based on the MK484 IC (formerly ZN414). It uses a PNP transistor and can drive a 150R loudspeaker
author: Chad Castagana, Woodland Hills, CA visits: 487 
A radio frequency amplifier to boost SW reception. Frequency range approximately 5 to 20 MHz
author: Andy Collinson visits: 453 
This Field Strength Meter is simple and also quite sensitive. It uses an ordinary digital voltmeter to measure RF signal strength up to a few hundred MHz
author: Andy Collinson visits: 449 
This is a wide band signal strength meter circuit which responds to small changes in RF energy, designed to be used for the VHF spectrum and will respond to AM or FM modulation or just a plain carrier wave.
author: visits: 441 
schematic for the 530 kHz to 1650 kHz AM Broadcasting Band
author: Ramon Vargas - Lima, Peru visits: 398 
A small FM voice transmitter for Band 2 VHF
author: David Sayles visits: 386 |
|
|
|---|